After dust mopping (or vacuuming) the floor, damp mop it (or
machine-scrub it) with a solution of water with our MB-1 Marble, Granite
& More Floor Cleaner using the correct mixing proportions (as
indicated on the back-label of the product). Once the floor is dry,
spray a mist of MB-10 over an area of approximately 50 square feet (4-5 m2)
and buff it while still wet using a high-speed burnishing floor machine
(1500 RPM rec.) with a proper polishing pad (natural hog-hair pads are
recommended, though not necessary). Repeat until the whole floor has
been restored. This procedure should be implemented on a daily frequency
basis in the most traffic-intense areas, such as doorways, front-desk
counters, elevators doors, etc. (make reference to the DIRECTIONS
printed on the back label of our MB-8). The final result should be a
perfectly shiny and uniform surface, with no “orange-peel” effect or
burnishing marks. If swirl-marks are detectable, spray some additional
MB-10 over the affected area and burnish immediately while still wet.
The directions above are for “average” situations. Should your
individual situation not allow for the daily maintenance routine, feel
free to contact us.
WARNING! CAUSES EYE IRRITATION. Keep out of reach of children. Avoid contact with eyes. Wash thoroughly after handling.
In case of contact, immediately flush eyes with plenty of water for at
least 15 minutes. If irritation persists, call a physician. If swallowed
drink plenty of water and call a physician immediately.
IN CASE OF EMERGENCY MAKE REFERENCE TO THIS PRODUCT’S MSDS @ www.mbstonepro.com