MB Stone Care MB-3 Soap Film and Mineral Deposit Remover is a product designed to get rid of unsightly and unsanitary soap film, scum, and hard water deposits effortlessly and without damaging the polished surface of your stone shower stalls. It works also great to clean the inside of that glass shower door from those hard-water deposits!

SHOWER FLOOR, WALLS AND DOORS, WASH BASINS,

ETC. - Dilute MB-3 in a proportion of 1 to 2 with warm water. Liberally apply with

a sponge and allow to stand - without letting the solution dry - until the soap

scum begins breaking up. Scrub slightly with a scrub brush or plastic scouring

pad. Rinse thoroughly. Repeat process if necessary. Drying is not required. Use

rubber gloves to avoid contact to the skin.

Keep out of reach of children.

Avoid contact with eyes, bare skin and clothing. Wash thoroughly after handling.

In case of contact, immediately flush eyes with clear water for at least

15 minutes. If irritation persists, call a physician. Flush skin with clear water. If

swallowed drink plenty of water and call a physician immediately.

Tetrasodium Ethylenediaminetetraacetate (C.A.S. #64-02-8), Sodium Metasilicate

(C.A.S. #6834-92-0), 2-Propanol (C.A.S. #67-63-0), Nonylphenolpolyethoxyethanol

(C.A.S. #9016- 45-9). Other substances in this product constitute

less than one percent.

IN CASE OF EMERGENCY MAKE REFERENCE TO THIS PRODUCT’S MSDS

(MATERIAL SAFETY DATA SHEET) AVAILABLE ON LINE @ www.mbstone.com.