A BALANCED MIX OF FINE NATURAL AND SYNTHETIC RESINS, THIS UNIQUE, NON-SLIP COMBINATION WILL INVISIBLY PROTECT THE FINISH (HIGH POLISH ONLY) OF NATURAL STONE AND URETHANE COATED HARDWOOD FLOORS, GREATLY REDUCING AND DELAYING THE VISUAL EFFECTS OF WEAR AND TEAR PATTERNS. WHEN PROPERLY APPLIED IT WON’T BUILD UP, THUS IT WON’T REQUIRE STRIPPING.
Directions for use:
Make sure that the floor to be treated is absolutely clean. Any possible coat of old wax must be thoroughly removed. Pour 1 cap full of MB-7 directly onto the glossy stone or hardwood surface and immediately spread it over an area of 20 or 30 square feet using a mop dampened with clear water only. Let it dry, then buff to a shine using “00” steel wool pads. Maintain by mopping the floor regularly with our specifically designed Marble & Hardwood Floor Detergent MB-1. Apply more where and when necessary. When scuff marks appear under traffic, buff them out with same “00” grit steel wool. For easier operation a floor polishing machine should be used (ask your dealer about our BDM Residential Floor Machine).
WARNING! CAUSES EYE IRRITATION.
Keep out of reach of children. Avoid contact with eyes. Wash thoroughly after handling.
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. If irritation persists, call a physician. If swallowed drink plenty of water and call a physician immediately.
Petroleum Wax (Micro) (C.A.S. #64742-42-3), Petroleum Wax (Paraffin) (C.A.S. #64742- 43-4), Modified Rosin Resin (C.A.S. #65997-10-6). Other substances in this product constitute less than one percent.
IN CASE OF EMERGENCY MAKE REFERENCE TO THIS PRODUCT’S MSDS (MATERIAL SAFETY DATA SHEET) AVAILABLE ON LINE @ www.mbstonepro.com.